![]() ![]() ![]() The service was restarting causing Windows Defender Antivirus to turn on, then AMP turns on again then back off, locking up the system. It didn't happen to all users just select few. If you have already upgraded to v7.4.1 and experience this problem, please contact Cisco Technical Assistance Center (TAC) and quote "AMP Windows 7.4.1 upgrade failure". If your system does not exhibit this behaviour after upgrade then no action is required.Īs a precaution, policy configurations that were scheduled to perform an upgrade to the new Windows Connector v7.5 have been rolled-back. Then access the Settings tab of the Antivirus. Get the best prevention, detection, and response with advanced, multi-layered defenses for all devices and operating systems - now cloud delivered with an intelligent. Click Protection on the left-hand side of the main interface. Our integrated products offer unparalleled protection and insight to reduce risk and lower costs across your entire organization. After the security agent installation, Windows Defender is automatically re-enabled if enforcement methods are in place (for example, GPO), or you can enable it through the available Windows controls. Reports indicate the AMP service may restart unexpectedly, sometimes repeatedly, after upgrade. Disable Protection features in Bitdefender 1. Windows security features (Windows Defender, Windows Firewall) will be automatically turned off before the agent installation is initiated. Symantec Endpoint Protection(Firewall Only, Latest version)ĪMP for Endpoints Windows Connector v7.5 has been removed from the AMP Console while we investigate reports of post-upgrade failures. I may have found a solution, which is to disable the service from group policy settings. ![]() What I have found is that the Microsoft Defender Antivirus service begins to run then locks up the system. A few seconds later, the whole system freezes and a hard reboot is necessary. I'm here to ask if anyone is experiencing lockups/freezes with the latest Windows 10 updates/build? My issue is, when our users workstations boot up and they log in, after 30-90 seconds Windows Defender warning comes up and says the threat service has stopped and there is no antivirus software running. My organisation has Windows Server 2016 OS and uses Symantec Endpoint Protection as the AV. ![]()
0 Comments
Leave a Reply. |